In order to prevent damage to the component, do not cut any deeper than necessary to remove the blower motor cup. Remove the 3 outer most screws from blower motor service ring, or blower integrated ring. Remove the blower motor assembly. Installation Procedure Clean and smooth the rough edges, and remove any burs of plastic from heater and air conditioning evaporator and blower lower module case, where the original blower motor assembly was cut out of the heater and air conditioning evaporator and blower lower module case.
Caution: Refer to Fastener Caution. Replacement Wheels Description Replace the wheel if any of the following conditions exist: The wheel exhibits excessive runout. The wheel is bent. The wheel is cracked. The wheel is severely rusted. The wheel is severely corroded. When the defrost position is selected, the HVAC control assembly will command the recirculation actuator to outside air, reducing window fogging. Regardless of the temperature setting, the following can affect the rate that the HVAC system can achieve the desired temperature:.
The temperature door controls the temperature of the air entering the passenger compartment. The position of the temperature door determines how much air passes through the heater or evaporator core.
As the temperature control is moved to a hotter setting, the temperature door will direct more air through the heater core.
As the temperature control is moved to a cooler setting, more air will be passed through the evaporator core. The recirculation actuator is a two-wire bi-directional electric motor. There are two control circuits that allow actuator operation. The control circuits use either a 0 or volt value to coordinate the actuator movement.
When the actuator is at rest, both control circuits have a value of 0 volts. To move the actuator, the HVAC control module grounds one of the control circuits while providing the other with 12 volts.
The HVAC control module reverses the polarity of the control circuits to move the actuator in the opposite direction. Exterior Lamp Controls The exterior lamp control is on the instrument panel to the outboard side of the steering column. There are four positions: Off : Briefly turn to this position to turn the automatic light control off or on again. A damaged LATCH system may not properly secure the child restraint, resulting in serious injury or even death in a crash.
To help make sure the LATCH system is working properly after a crash, see your dealer to have the system Caution: Support the brake caliper with heavy mechanic wire, or equivalent, whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the f Home New Top Sitemap Search.
If the control module is not properly configured with the correct calibration s Other materials: Exterior Lamp Controls The exterior lamp control is on the instrument panel to the outboard side of the steering column.
0コメント